EasyManuals Logo
Home>Mitsubishi>Engine>S16R-PTA2-C

Mitsubishi S16R-PTA2-C User Manual

Mitsubishi S16R-PTA2-C
216 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #147 background imageLoading...
Page #147 background image
8 INSPECTION AND MAINTENANCE
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
147
Pub. No. K29001-00320 Revision: 1
5 Align the phase and angle between
the joint (1) and the hose (2) as they
were when removed.
• Always replace the sealing washer with a
new one once it is disturbed.
Fig. 8-28 Joint, Hose
6 Install the banjo bolt in Step 4 to the
fuel feed pump.
• Tool: Torque wrench
• Tightening torque:
30 to 38 N·m {3.06 to 3.87 kgf·m}
[22.13 to 28.03 ibf·ft]
• Always replace the sealing washer with a
new one once it is disturbed.
Fig. 8-29 Banjo Bolt - Install
7 Bleed air from the fuel filter
"Fuel
Filter - Bleed Air" (→ Page 144).
Fuel Filter - Replace
• For the location of the fuel filter, refer
to
"2 ENGINE - OUTLINE" (→ Page 73).
(2)
(1)
Do not pour fuel into the fuel filter
before installing it.
* Otherwise, it may cause serious personal injury,
environmental pollution due to fuel running to
outside of the facility, or damage to the devices.
* Follow the installation procedure described in
this Operation & Maintenance Manual.
Use a genuine fuel filter.
* If a non-genuine filter is used, , deterioration in
the exhaust gas properties and damage to the
devices could occur due to insufficient air
intake.
* Faults or damages caused by using non-
genuine parts will be outside the scope of the
warranty.
Do not use a fuel filter with a scratch
or dent.
* Otherwise, damage to the filter or fuel leak may
occur, which could cause a fire or
environmental pollution due to fuel running to
outside of the facility.
Do not use a filter wrench when
installing the fuel filter.
* It may cause a dent or damage to the fuel filter.
If fuel spills out while removing the
fuel filter, wipe off with a waste cloth.
* Otherwise, it may cause a fire or environmental
pollution due to fuel running to outside of the
facility.
* The waste cloth used to wipe off fuel shall be
discarded in according with the local laws and
regulations as well as the manufacturer's SDS.
Check the specification of the fuel
filter when installing it.
* The fuel filter of which specification does not
apply to the fuel may cause damage to the
devices.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi S16R-PTA2-C and is the answer not in the manual?

Mitsubishi S16R-PTA2-C Specifications

General IconGeneral
BrandMitsubishi
ModelS16R-PTA2-C
CategoryEngine
LanguageEnglish

Related product manuals