3 OPERATION
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
88
Pub. No. K29001-00320 Revision: 1
3 OPERATION
This chapter describes the operation procedures.
Operation - Outline
The method of operation depends on the intended
use and starting system of the engine.
Refer to "SPECIFICATIONS - CHECK" (→ Page
10), and check the intended use and starting
system previously.
The flow of operation is as shown in the diagram
below.
<Intended use>
:Continuous use engine
:Emergency use engine
<Starting system>
:Common to all starting systems
:Self Starter Motor Starting
:Air Direct Admission Starting
:Air Motor Starting
1 Daily Check
• Operational Environment - Check
• Engine Exterior - Check
2 Pre-operation Check
• Fuel Tank Oil Level - Check
• Fuel Control Link - Check
• Engine Oil Level - Check
• Coolant Level - Check
• Battery - Check
• Pre-cleaner - Check for Clogging
• Air Cleaner - Check for Clogging
• Damper Temperature - Check
• Manual Turning Gear - Check
• Air Direct Admission Starting - Check
• Air Motor Starting - Check
3 Engine Start-up
• Self Starter Motor Starting
• Air Direct Admission Starting
• Air Motor Starting
4 Warm-up Operation
5 Operation
• Checking During Operation
6 Cooling Operation
7 Stopping
8 Checking After Stopping
Maintenance Operation
Continuous
Emergency
Common
Self starter
Air direct
Air motor
Continuous
Emergency
Common
Continuous
Emergency
Common
Common
Common
Common
Common
Common
Common
Common
Common
Air direct
Air motor
Continuous
Emergency
Self starter
Air direct
Air motor
Continuous
Emergency
Common
Continuous
Emergency
Common
Continuous
Emergency
Common
Continuous
Emergency
Common
Continuous
Emergency
Common
Continuous
Emergency
Common
To Next Page
Loading...
Need help?
General
