1 SAFETY
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
48
Pub. No. K29001-00320 Revision: 1
<Oil Filter - Replace> <Governor Oil Filter - Replace
(Hydraulic governor spec)>
â– Cooling System - Check
<Cooling System - Clean>
When replacing the oil filter, do not
pour the remaining engine oil in the
old filter into the new filter.
* Otherwise, foreign particles could enter the
engine oil system, which could cause damage
to the devices.
Before replacing the oil filter, make
sure that the engine has cooled down
to the normal temperature.
* Otherwise, you could get burned by heat.
Use a genuine oil filter.
* Using non-genuine parts could cause damage
to the devices or degradation in the
performance.
* Faults or damages caused by using non-
genuine parts will be outside the scope of the
warranty.
If paint or other matter is adhering
around the sealing surface, remove
them before assembling.
* If paint or other matter is stuck on the sealing
surface, fuel could leak through the gap, which
could cause a fire.
If engine oil spills out while removing
the oil filter, wipe off with a waste
cloth.
* Otherwise, it may cause a fire or environmental
pollution due to fuel running to outside of the
facility.
* The waste cloth used to wipe off engine oil shall
be discarded in according with the local laws
and regulations as well as the manufacturer's
SDS.
Do not use the oil filter with a scratch
or dent.
* Otherwise, damage to the filter or oil leak may
occur, which could cause a fire or
environmental pollution due to fuel running to
outside of the facility.
Do not use a filter wrench when
installing the oil filter.
* It may cause a dent or damage to the oil filter.
When replacing the oil filter, set the
gasket into the groove properly.
* Otherwise, engine oil leak could occur, which
could cause a fire or environmental pollution
due to oil running to outside of the facility.
* Follow the replacing procedure described in this
Operation & Maintenance Manual.
Do not touch hot engine oil or parts.
* Otherwise, you could get burned.
Do not continue to operate the engine
with engine oil mixed in coolant.
* Otherwise, cooling fault may occur, which could
cause damage to the engine.
Do not open the radiator cap or
coolant tank cap while the engine is
hot.
* Otherwise, you could get burns by steam or
water splashing out.
Tighten the drain cock on the water
pump properly.
* Insufficient tightening may cause a coolant leak.
Follow the coolant draining procedure
described in this Operation &
Maintenance Manual.
* Draining in the incorrect procedure may cause
burns or environmental pollution due to coolant
running to outside of the facility.
When handling cleaning solution for
washing the cooling system, obey the
manufacturer's SDS.
* Improper wearing or using of personal
protective equipment may cause personal
injury.
When handling cleaning solution for
washing the cooling system, obey the
manufacturer's SDS.
* Improper wearing or using of personal
protective equipment may cause personal
injury.
To Next Page
Loading...
Need help?
General
