Assembly instructions BA-100155
Control unit MonTurn
13
3.4 Changes and modifications to the equipment
In order to avoid hazards and to ensure optimum performance, the unit must not be subjected to any
modifications, additions or conversions that have not been expressly approved by the manufacturer.
3.5 Personal protective equipment
The wearing of personal protective equipment is required during work to minimize health hazards.
Safety shoes
To protect against heavy dropped parts and slipping on slippery surfaces.
Hairnet
Hair nets must be worn when working on machines with rotating parts.
3.6 Personnel requirements
The different tasks described in this manual pose different requirements for the qualification of the persons
assigned to perform the tasks.
For all work, only allow persons to perform the work who can be expected to perform it reliably. Persons whose
ability to respond is impaired, e.g. due to drugs, alcohol or medications, shall not be allowed to work on the
machine.
What follows is a list the personnel qualifications for the different tasks:
Machine operator
The machine operator has been instructed by the system operator regarding the tasks assigned to him/her and
the potential hazards in case of improper behavior. The machine operator may perform tasks going beyond
operation in the normal operation mode only if this task has been explicitly assigned by the system operator.
Skilled electrician
A skilled electrician is, due to his/her technical training, knowledge and experience, as well as knowledge of the
applicable standards and regulations, able to perform work on electrical systems and to independently recognize
potential dangers and avoid hazards.
The skilled electrician has been trained specifically for his/her work environment and is familiar with the relevant
standards and regulations.
Skilled personnel
The skilled personnel is, due to their technical training, knowledge and experience, as well as knowledge of the
applicable standards and regulations, able to perform work assigned to them and to independently recognize
potential dangers and avoid hazards.
Manufacturer
Certain work may only be performed by Montech AG’s skilled personnel. Other personnel shall not be
authorized to perform this work. Please contact our Customer Service to have such work performed.
To Next Page
Loading...
Need help?
General
