MOTORGUIDE WIRELESS
8M4000137 For Questions, Contact Consumer Affairs at #1-920-929-5040 17
© 2005, MotorGuide www.motorguide.com
Activating the Foot-Pedal Electronic ID
Each foot-pedal has a unique electronic ID number. Up to four electronic ID
numbers (Digital Remote Control units and/or foot-pedals) can be stored by
your receiver. For your foot-pedal to respond to your commands only and not
those of other boaters, you must activate the electronic ID number into your
receiver. Follow the instructions below (one time only) to activate each new
remote control device:
1. Connect the motor to a power source - within 10 seconds, press and
hold the “+” and “-“ buttons on the foot-pedal simultaneously
2. Listen for a long beep
3. The receiver has now learned and stored the electronic ID number of
the foot-pedal.
If you are activating multiple remote control devices (up to four devices
can be accommodated) the motor must be disconnected from the power
source and reconnected to the power source between activating each
remote control device.
NOTE
Erasing the Receiver’s Memory
To erase all electronic ID numbers stored in the receiver’s memory:
1. Power-up the motor
2. Within 10 seconds, press and hold the “Left”, “Right”, “+” and “-“
buttons on the foot-pedal simultaneously
3. Listen for a long beep indicating the receiver has erased all stored
electronic ID numbers
To Next Page
Loading...
Need help?
General
