37
Using the answering machine
At the end of playback:
You will hear, ’End of messages. To delete all messages, press delete’. To
delete all messages, press
, you will hear, ’All messages deleted’. If you
do not press any buttons during the countdown the display will return
to idle.
10.5 Adjust the speaker volume
You can adjust the base loudspeaker volume from low to high. Press to
increase the volume, or
to decrease the volume.
Outgoing messages (OGMs)
The outgoing message is the message a caller rst hears when the
answering machine picks up their call.
Your C1 product has two pre-recorded outgoing messages, Answer & Record
or Answer Only, and you can also record your own.
The pre-set Answer and Record outgoing message, that allows your caller
to leave a message, is ’Hello, your call cannot be taken at the moment, so
please leave your message after the tone’.
10.6 Record your own OGM
This will replace the pre-recorded or your own previous outgoing message.
However, you can re-instate the pre-recorded OGM at any time by deleting
your own recorded OGM.
Using the handset:
1. Press
, scroll to
TAM SETTINGS
and press .
2. Scroll
to
OGM SETTING
and press .
3. Scroll
to
RECORD OGM
and press .
4. Press
or to select either
ANS AND REC
or
ANS ONLY
and press .
5. Place the handset to your ear. You will hear, ’Please speak after the tone.
To end recording, press #’.
6. After the long beep speak your message slowly and clearly into the
handset, to end recording press
. Your message will then be played
back to you through the handset.
10.7 Answer Only
With Answer Only selected, your caller will hear an announcement only
and will not be able to leave a message. The pre-set Answer Only outgoing
message is ’Hello, your call cannot be taken at the moment and you cannot
leave a message, so please call later’.
To Next Page
Loading...
Need help?
General
