Clock & Alarm 19
6. Clock & Alarm
If you subscribe to your network’s Caller Identification service, the time on
your D1011 may be set automatically each time you receive a call,
depending on your network provider.
You can also set or adjust the time using the Clock & Alarm menu.
Set date and time
1.
Press m and scroll d to
CLOCK/ALARM
. Press m. Display shows
DATE & TIME
, then press m.
2.
Enter the date using the format
DD/MM
e.g.
04/ 08
for 4th August.
3.
Press m and enter the time using the 24 hour format
HH:MM
,
e.g. 14:45 for 2.45pm.
4.
Press m to confirm.
5.
Press > to return to standby.
NOTE
The date and time is retained during a power failure or when the batteries
are discharged.
Set alarm
1.
Press m, scroll d to
CLOCK/ALARM
and press m.
2.
Scroll d to
SET ALARM
and press m.
3.
Scroll u or d to
OFF
,
ON ONCE
or
ON DAILY
and press m.
4.
If you select
ON ONCE
or
ON DAILY
, enter the time using the 24 hour
format
HH - MM
e.g 14:45 for 2:45pm and press m.
5.
Press > to return to standby. When the alarm goes off, press any
key to stop the ring.
NOTE
Once the alarm is set to on, the icon is displayed.
The alarm will ring at the medium level.
ALARM ON
and the will flash on
the display.
Set alarm melody
There are three alarm ringtones.
1.
Press m and scroll d to
CLOCK/ALARM
.
Press
m.
2.
Scroll d to
ALARM TONE
and press m.
- Melodies are played.
3.
Scroll u or dand press m.
To Next Page
Loading...
Need help?
General
