Advanced settings 25
Auto prefix
You can set the D1011 to detect a dialling number and replace it with
another number. The number to be detected can be up to 5 digits long. It
can be replaced with a number up to 10 digits.
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
Scroll d to
PREFIX
. Press m.
3.
DETECT DIGIT
is displayed. Press m.
4.
Enter the number you want to be detected and press m.
5.
Scroll to
PREFIX NUM
. and press m.
6.
Enter the number you want it replaced with and press m.
7.
Press > to return to standby.
Country
If you move to another country you can set your phone to be compatible
with the network settings of that country.
Depending on your country, this option may be displayed as
NOT AVAIL
or
you country may not be displayed.
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
Scroll d to
SEL. COUNTRY
. Press m.
3.
Enter the 4-digit master PIN and press m.
4.
Scroll u or d to display the required country.
5.
Press m to confirm.
Intrusion
When an external call is taking place, another handset registered to the
base can join in, making the call a 3-way conference, just by pressing
<.
To enable this, Intrusion must be switched On.
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
Scroll d to
INTRUSION
. Press m.
3.
Scroll u or d to
ON
or
OFF
.
4.
Press m to confirm.
5.
Press > to return to standby.
ECO mode
To reduce the level of power emissions, you can select low power or ECO
mode. When the ECO mode is set to
ON
, the base transmission power will
be reduced.
To turn ECO Mode to
ON
or
OFF
:
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
Scroll d to
ECO MODE
and press m.
3.
Press u or d to highlight
ON
or
OFF
then press m to confirm.
- A confirmation beep is emitted and the handset display will switch
between the handset’s name and
ECO MODE
.
NOTE
When Eco Mode is set to
ON
, the handset range will be reduced.
To Next Page
Loading...
Need help?
General
