Wall mounting 33
Press and hold # to insert a pause (P) before entering the telephone
number.
You may also need to enter a pause when storing international numbers
or charge card numbers.
Recall
You may need to use the recall function if you are connected to a
switchboard/PABX (Private Automatic Branch Exchange), contact your
PABX supplier for further information.
12. Wall mounting
IMPORTANT
Before you wall-mount your D1011, check that you are not drilling into any
hidden wiring or pipes.
Before you drill, make sure the power and telephone line cables will reach
the sockets.
1.
Use the following templates to mark the drilling locations.
• To wall-mount the base, drill two holes in the wall 4.5cm apart
horizontally using an 8mm drill bit.
• To wall-mount the charger, drill two holes in the wall 3.2cm apart
horizontally using an 8mm drill bit.
To Next Page
Loading...
Need help?
General
