16 Parent Unit Menu Options
4.6.3 Delete a camera
1. Press the M Menu button and the menu bar will pop up.
2. Press the
< LEFT button or > RIGHT button until C is highlighted, and
the /
+//
menu will pop up.
3. Press the
+ UP button or - DOWN button to select , and press the OK
button to confirm.
4.
C 1 / C 2 / C 3 / C 4 will pop up, press the + UP button or - DOWN button
to select the desired CAM, and press the OK button to select.
5. Press the
+ UP or - DOWN button to select
X
, and press the OK button
to delete that registration.
4.6.4 Scan the cameras
1. Press the M Menu button and the menu bar will pop up.
2. Press the
< LEFT button or > RIGHT button until C is highlighted, and
the /
+//
menu will pop up.
3. Press the
+ UP button or - DOWN button to select , and press the OK
button to confirm.
4. The screen will then display images from each registered camera in a loop,
changing about every 12 seconds.
TIP
Press OK repeatedly for a quick way to go to mode without using the menu.
NOTE
If the parent unit is in scan mode and one of the registered cameras is turned off
or out of range, the scan will stop at the missing camera, display "no signal -
check or del cam 1" (if camera 1 is missing), and emit a warning beep every 5
seconds.
WARNING
Check the camera and correct the fault immediately if you are using that
camera to monitor your baby.
If you want to continue in camera scan mode without that camera, delete the
camera (see 4.6.3 Delete a camera) and start the scan again.
4.7 Temperature
1. Press the M Menu button and the menu bar will pop up.
2. Press the
< LEFT button or > RIGHT button until t is highlighted.
3. Press the
+ UP button or - DOWN button to select °C or °F.
To Next Page
Loading...
Need help?
General
