9Getting started
1. Plug the power adaptor into the socket marked P on the underside of the charger and
plug the other end into the mains power wall socket.
2. The 750mAh Ni-MH battery pack is pre installed. If you are charging the batteries
for the rst time, place the handset on the charger to charge for at least 24 hours
continuously.
3. When the handset is fully charged,
icon will appear steady on the display. The
display will show the time and handset number (e.g. 2) to indicate that it is registered
to the base. Plug the other end of the telephone line cord (make sure that one end is
already plugged into the base) into the telephone wall socket.
NOTE
Both power adaptors are identical, hence can be interchanged. This unit adapts Inductive
Charging, as such there will be no metal contacts on the handset or charging cradle.
Replacing the handset battery
1. Unscrew the belt clip, then unscrew the 4 screws on the battery cover (the screws will
stay attached to the battery compartment door) from the back of the handset and plug
in the 750 mAh Ni-MH rechargeable battery pack supplied.
2. Replace the battery cover and screw the cover into place. Finally, screw the belt clip on.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery pack (750mAh Ni-MH
rechargeable battery pack) supplied with your O2.
To Next Page
Loading...
Need help?
General
