PROGRAMMING
FEATURES
English
49
Time-Out Timer
This timer sets the amount of time that the
radio can continuously transmit before
transmission is automatically terminated. The
default setting is 60 seconds and can be
changed using the CPS.
Power Select
Power Select allows you to select between
high and low transmission power per channel.
The power levels for RM Series toggle
between 2W and 1W.
Call Tones
Call Tones feature allows you to transmit
an audible tone to other radios on the
same channel and alerting them that you
are about to talk or alerting them
without speaking. The call tones feature
must be programmed to SB1 or SB2 and 1
of 3 pre-recorded tones selected
Scramble
The Scramble feature makes transmissions
sound garbled to anyone listening without the
same code. Scramble default value is OFF.
The Scramble feature should be
programmed to SB1 or SB2, If the scramble
code need to be changed during radio's
normal operation.
Reverse Burst
Reverse Burst eliminates unwanted noise
(squelch tail) during loss of carrier detection.
You can select values of either 180 or 240
to be compatible with other radios. Default
is 180.
Notes:
•
The features described in previous pages
are just some of the features CPS has. CPS
offers more capabilities. For more information
refer to the HELP file in the CPS.
•
Some of the features available with the CPS
software may vary depending on the radio
model.
To Next Page
Loading...
Need help?
General
