CHAPTER 3
AMI
®
BIOS USERS GUIDE
3-10
Description of the item on screen follows:
Set SDRAM Timing By SPD
Choose Enabled, will automatically configure the DRAM Timing
depending on the “DRAM Speed” selection. Choose Disabled, to customize
the setup.
DRAM Frequency
This item specify the DRAM frequency of the system. The
settings are HCLK-33 (FSB-33), HCLK (FSB) and HCLK+33 (FSB+33).
SDRAM CAS# Latency
When synchronous DRAM is installed, the number of clock cycles
of CAS latency depends on the DRAM timing. The settings are: 2 and 3.
DRAM Integrity Mode
This item will automatically detect your DIMM for ECC. The setup
and BIOS default setting is Disabled.
AGP Mode
This setting automatically detect if graphics card is available or not.
AGP Driving
This setting allows you to adjust the AGP driving. It is recom-
mended you leave this set to Auto.
Memory Hole
This option allows the end user to specify the location of a memory
hole (15MB-16MB). The cycle matching the selected memory hole will be
passed to the ISA bus.
To Next Page
Loading...
Need help?
General
