CHAPTER 3
AMI
®
BIOS USERS GUIDE
3-21
Parallel Port IRQ
If the onboard parallel mode is not on auto mode, the user can select
the interrupt line for onboard parallel port. We suggest that the user select
the interrupt for the onboard parallel port as shown below:
Onboard parallel port set at
Parallel Port IRQ
LPT1(378H)
LPT2(278H)
LPT3(3BCH)
7
5
5
Parallel Port DMA
This option allows user to choose DMA channel 1 to 3 for the
onboard parallel port on ECP mode.
AC’97 Audio
This item allows you to decide to enable/disable the VIA chipset
family to support AC97Audio. The settings are Auto, Enabled or Disabled.
MC’97 Modem
This item allows you to decide to enable/disable the VIA chipset
family to support MC97 Modem. The settings are Auto, Enabled or Disa-
bled.
USB Controller
This option allows you to select the on-chip USB controller. The
settings are USB Port 0 & 1, USB Port 2 & 3 or All USB Port. The default
setting is USB Port 0 & 1.
To Next Page
Loading...
Need help?
General
