MS-7346 Mainboard
B-12
There is an application called NVRAIDMAN which helps you perform the following
tasks of nVDIA RAID.
• Viewing RAID Array Configurations
View an array configuration (mirrored, striped, mirror-striped, JBOD, or any sup-
ported combination)
• Setting Up a Spare RAID Disk
• View free and/or dedicated free disks
• Designate a free disk to a particular array
• Creating RAID Arrays
• Deleting a RAID Array
• Morphing From One RAID Array to Another
• Hot Plug Array
• Initializing a RAID Array
• Erase the data on the array by writing all zeros to the sectors of each hard
disk.
• Rebuilding a RAID Mirrored Array
• Rebuild a broken mirrored array
• Watch the progress of rebuilding an array
• Only applies to RAID 1, RAID 0+1, and RAID 5 arrays
• Synchronizing a RAID Array
• Rebuild the redundancy in RAID 1 or RAID 0+1 arrays (copy the data to the
redundant disk—the same operation as rebuilding)
• Rebuild the parity in RAID 5 arrays
Viewing RAID Array Configurations
To view your RAID configuration from Windows, launch the NVRAID Management
utility by double-clicking NvRaidMan.exe (the default location of NvRaidMan.exe is in
\\nVidia\System\MCP55\IDE\Win2k\raidtool\ of the setup CD accompanied with your
mainboard).
The RAID configuration information appears in the right-side pane, as shown below.
NVRAID Management Utility
Important
The information in the figures in this part may very from what it is shown in
your system.
7346v1.0-B_NVRAID.p65 2007/3/6, 上午 11:5812
To Next Page
Loading...
Need help?
General
