2-25
Hardware Setup
5. After the hardware installation is completed, restart the system and install the NV
SLI driver/utility. A configuration panel will be provided for Multi-GPU control. Check
the Enable multi-GPU box to enable the SLI function for the onboard graphics
cards (concerning the details of multi-GPU settings, please refer to your graphics
card manual) .
6. Restart your system and a pop-up message will show in the system tray confirm-
ing that Multi-GPU has been enabled.
Check the box
Important
If you want to remove one graphics card and quit the SLI function, make sure
that you reset the SLI switch card (SLI mode to non-SLI mode) and disable the
"MultiGPU" function.
7346v1.0-2-Hardware.p65 2007/3/6, 上午 11:5825
To Next Page
Loading...
Need help?
General
