Chapter 5 Maintenance and Inspection
UD-series Screw Compressor 5.3 Compressor Disassembly Preparation
5-8
5.3.2 Replacement Parts
Prepare the genuine parts for replacement.
Parts listed in Table 5-5, we recommend to be replaced on the occasion of each compressor overhaul.
For each part size and code No. of each compressor model, refer to Section 7.2 "Parts Configuration
Table" in this manual Chapter 7.
When ordering parts, be sure to inform the (a) model name, (b) serial number, (c) part name, (d) code
No. and (e) quantity required, to our sales offices or service centers.
In particular, if the serial number (b) is unknown, the details of the applicable design and manufacturing
specifications cannot be identified, and thus it becomes difficult to choose correct parts.
Table 5-5 Replacement Parts of UD-series Compressor Overhauling
9 O-ring, Suction Cover
Gasket, Balance Piston
Cover
1 1 1 1 1
1
30 Balance Piston To be replaced if any abnormality is
found.
O-ring, Balance Piston
Sleeve
1 1 1 1 1
1
To be replaced if any abnormality is
found.
2 2 2 2 2
2
O-ring, Oil Seal Retainer
O-ring, Unloader Cylinder
65 O-ring, Unloader Piston
To be replaced if any abnormality is
found.
1 1 1 1 1
1
Lock Nut, Unloader Piston
To be replaced if any abnormality is
found.
1 1 1 1 1
1
Lock Washer, Unloader
Piston
1 1 1 1 1
1
O-ring, Unloader Push Rod
Ball Bearing, Unloader
Cylinder Cam
1 1 1 1 1
1
Retaining ring C type
External
1 1 1 1 1
1