NAD T 747 User Manual

SETUP MENU
The Setup Menu allows one to customize the operation of the T 747 to the
ancillary equipment used in one’s specic AV system. Unless your system
exactly matches the factory defaults, you will need to use the Setup Menu
to congure the settings of your T 747.
At Setup Menu, the following are congurable – A/V Presets, Source Setup,
Speaker Setup, Amplier Setup, Trigger Setup, Listening Mode Setup, Front
Panel Display Setup and Video Setup.
To navigate through these Setup Menu options and their sub-menu
selections, please refer to above section about “DISPLAY THE OSD” and
“NAVIGATING THE OSD AND MAKING CHANGES”.
A/V PRESETS
The T 747’s simple but powerfully exible system of “Presets” allows you
to customize virtually every aspect of your audio-video playback, and
recall them with a single key-press. The parameters “Listening Mode”, “DSP
Options”, “Tone Controls”, “Speaker Setup” and “Front Panel Display Setup”
settings are stored together as a Single Preset.
You might create one Preset optimized for pop music and another for
classical. One more Preset can be set up to recall each family member’s
favorite setting or one for fully cinematic home-theater playback and
yet another one for late-night movies, with each Preset ne-tuned to a
particular scenario or preference.
CREATING PRESETS
Creating a Preset consists simply of storing a complete set of the
parameters set forth in the “Listening Mode”, “DSP Options”, “Tone Controls”,
“Speaker Setup” and “Front Panel Display Setup” congurable through
“Setup Menu”.
Go to “A/V Presets” to save a collection of said parameter settings to a Preset.
Select a Preset number and you can then selectively include in this particular
Preset number any of the above-mentioned parameter settings by choosing
“Yes”. If you decide not to include in the particular Preset a certain parameter
setting, select “No”.
Now in order to save the settings chosen for the particular Preset number,
scroll down to “Save Current Setup to Preset” and press the [ ] key. If you
chose to load instead the default settings, scroll down to “Load Defaults to
Preset” and press the [ ] key to restore the default settings.
In addition to the parameter settings, the Preset label itself can be assigned a
new name. This new Name will be shown in the VFD as well as on the OSD.
To rename the Preset label, scroll to “Name” and press [ ] to go the
character. Then, press [ ] to pick and select through the alphanumeric
selections. Press [ ] to move to the next character or back to the
previous character and at the same time save the changes done on the
current character.
OPERATION
USING THE T 747  SETUP MENU
18
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ

NAD T 747 Specifications

General

Brand	NAD
Model	T 747
Category	Receiver
Language	English