Getting Started with the PXIe-8861
This document includes instructions for installing and configuring your
PXIe-8861PXI Express controller module.
© 2019–2020National Instruments Corporation. All rights reserved. Refer to the
<National Instruments>\_Legal Information directory for information about NI
copyright, patents, trademarks, warranties, product warnings, and export
compliance.
Getting Started with the PXIe-8861
This section includes instructions for unpacking and installing your PXIe-8861
controller. It also describes the controller's front panel connectors.
Caution Using the PXIe-8861 controller in a manner not described in
this guide can impair the protection the controller provides.
Unpacking
The PXIe-8861 ships in an antistatic package to prevent electrostatic discharge from
damaging device components. To prevent such damage when handling the device,
ground yourself using a grounding strap or by holding a grounded object, such as
your computer chassis, and complete the following steps:
1.
Touch the antistatic package to a metal part of the chassis before removing
the device from the package.
Caution Never touch the exposed pins of connectors.
2.
Remove the device from the package and inspect the device for loose
components or any other sign of damage.
3.
Notify NI if the device appears damaged in any way. Do not install a damaged
device into your chassis.
© National Instruments
3
PXIe-8861 Getting Started Guide
To Next Page
Loading...
Need help?
General
