Notice that when both channel faders are down, there is no signal at all coming through
the headphones.
6. Move the crossfader from one side to the other to hear the main mix in the headphone
cue.
Remember that no matter what mix you are hearing in your headphones, the main mix is
still controlled by the crossfader and channel faders.
3.1.4 Filter Mode
The Z1 contains a FILTER | FX knob above each of its channel faders, and a corresponding ON
button. With the FILTER mode enabled, the FILTER | FX knob operates much like a standard
filter. Turning the knob clockwise cuts the low end frequencies, whereas turning counterclock-
wise cuts the high end. Again, you will be able to see how moving this knob simultaneously
moves the corresponding filter within the TRAKTOR software.
►
To activate the FILTER function, press the ON button so it illuminates blue.
Press the ON button again to turn the FILTER function off. The button will become unillu-
minated when in the off state.
Switching TRAKTOR's Filter Type Using the Z1
The Z1 provides two available Filter types to choose from within TRAKTOR, the (default) Z Fil-
ter, and ladder Filter. To switch the Filter type:
1. Make sure that the Z1's FILTER buttons are both turned off (unilluminated).
2. Press the MODE button.
→
The MODE button will become backlit to indicate this change has taken place.
1. To activate the (ladder) FILTER, press either of the Z1's ON buttons so that they illumi-
nate blue.
To switch back to the Default Z Filter, simply repeat the above process again.
Using the Z1 with TRAKTOR
Key Z1 Functions Using TRAKTOR
TRAKTOR KONTROL Z1 - Manual - 13
To Next Page
Loading...
Need help?
General
