4.1.5 Filter Mode
With the FILTER mode enabled, the FILTER | FX knob operates much like a standard filter.
Turning the knob clockwise cuts the low end frequencies, whereas turning counterclockwise
cuts the high end.
►
To operate the FILTER function, press the ON button so it illuminates blue.
4.1.6 FX Mode
The second function on the FILTER | FX knob controls the FX parameter of the Z1.
Note that this FX Mode only applies when using the Z1 with TRAKTOR DJ!
►
Press MODE + ON to switch to the corresponding FX mode.
→
You will notice the ON button's dim backlighting switches from blue to orange.
►
To engage the (internally selected) TRAKTOR DJ effect, press the ON button again.
→
The ON button is engaged and fully illuminated orange.
TRAKTOR DJ has three banks of available effects, each of which contains eight effects.
Once a single effect is internally selected, the FILTER | FX knob will then control that pa-
rameter, or the amount of the effect applied.
The FILTER | FX knob controls the X axis of the XY pad of the selected TRAKTOR DJ effect.
To control the Y parameter of the effect you can do so by touching it within TRAKTOR DJ.
You'll notice that the selected effect is altered in a different way when manually adjusted
this way.
When no FILTER or FX mode is required, press the ON button again so that it is not illumi-
nated.
Using the Z1 with TRAKTOR DJ
Key Z1 Functions Using TRAKTOR DJ
TRAKTOR KONTROL Z1 - Manual - 18
To Next Page
Loading...
Need help?
General
