Neato Robotics botvac connected User Manual

5
Preparation and Set Up
IMPORTANT
Remove all protective films and shipping
material from the robot and charge base.
If they are not removed, Neato will not
operate correctly.
Plug the power cord securely into the
charge base.
Adjust the length of the cord by wrapping
it as shown.
IMPORTANT
Open the dirt bin and remove the tab.
Push DOWN on the switch to power
on the robot
Put the dirt bin back in the robot.
1 Remove Films and Stickers 3 Set Power Switch On
Choose a wall outlet that has a 3’ (1 m)
clearance on both sides and in front of the
charge base. This helps your robot find the
charge base.
Plug in the power cord and push the charge
base against the wall.
Tip: Locate the charge base on a hard floor
surface.
Tip: Make sure the power outlet is not
controlled by a switch.
OFF
ON
2 Set Up Charge Base
OFF
NO
Tab

Neato Robotics botvac connected Specifications

General

Shape	D-shape
Product color	Black
Built-in display	Yes
Dust container type	-
Dust capacity (total)	- L
AC input voltage	110-220 V
Battery capacity	- mAh

Weight and Dimensions

Depth	321 mm
Width	335 mm
Height	100 mm
Weight	4100 g