EasyManuals Logo
Home>NEC>Monitor>MultiSync EA275WMi

NEC MultiSync EA275WMi User Manual

NEC MultiSync EA275WMi
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
English-2
Registration Information
FCC Information
1. Use the attached specifi ed cables with the MultiSync EA275WMi (L273QL)/MultiSync EA305WMi (L303QW) monitor so
as not to interfere with radio and television reception.
(1) The power supply cord you use must have been approved by and comply with the safety standards of U.S.A.,
and meet the following condition.
Power supply cord
Plug shape
Non shield type, 3-conductor
U.S.A
(2) Please use the supplied shielded video signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult your dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions.
The user may fi nd the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify
and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S. Government Printing Offi ce,
Washington, D.C., 20402, Stock No. 004-000-00345-4.
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
U.S. Responsible Party: NEC Display Solutions of America, Inc.
Address: 500 Park Boulevard, Suite 1100
Itasca, Illinois 60143
Tel. No.: (630) 467-3000
Type of Product: Display Monitor
Equipment Classifi cation: Class B Peripheral
Model: MultiSync EA275WMi (L273QL)
MultiSync EA305WMi (L303QW)
We hereby declare that the equipment specifi ed above conforms
to the technical standards as specifi ed in the FCC Rules.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC MultiSync EA275WMi and is the answer not in the manual?

NEC MultiSync EA275WMi Specifications

General IconGeneral
3DNo
Panel typeAH-IPS
Pixel pitch0.265 x 0.265 mm
Aspect ratio16:9
Screen shapeFlat
Pixel density109 ppi
Response time6 ms
Backlight typeW-LED
Composite syncYes
Display surface-
Display diagonal27 \
Display technologyLED
Horizontal scan range31.5 - 83 kHz
Viewable size diagonal684.7 mm
Viewable size, vertical335.7 mm
Contrast ratio (dynamic)20000:1
Contrast ratio (typical)1000:1
Display number of colors16.78 million colors
Viewable size, horizontal596.7 mm
Digital vertical frequency56 - 75 Hz
Digital horizontal frequency31.5 - 91 kHz
Display brightness (typical)350 cd/m²
Supported graphics resolutions640 x 480 (VGA), 720 x 400, 800 x 600 (SVGA), 832 x 624, 1024 x 768 (XGA), 1152 x 870, 1280 x 1024 (SXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 1920 x 1080 (HD 1080), 2560 x 1440
USB hub version3.2 Gen 1 (3.1 Gen 1)
DVI-I ports quantity1
Headphone connectivity3.5 mm
VGA (D-Sub) ports quantity0
USB Type-A downstream ports quantity3
Height adjustment130 mm
Panel mounting interface100 x 100 mm
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Annual energy consumption60 kWh
Power consumption (standby)0.44 W
Power consumption (typical)57 W
Operating altitude0 - 5000 m
Non-operating altitude0 - 12192 m
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)5 - 35 °C
Storage relative humidity (H-H)10 - 85 %
Operating relative humidity (H-H)20 - 80 %
Sustainability certificatesENERGY STAR
CertificationTCO, RoHS
Product colorBlack
Cables includedAC, DisplayPort, USB
RMS rated power2 W
Number of speakers2
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)230 mm
Width (with stand)369.2 mm
Height (with stand)417.9 mm
Weight (with stand)8700 g
Depth (without stand)72 mm
Width (without stand)639.2 mm
Height (without stand)377.8 mm
Weight (without stand)5800 g

Related product manuals