English
English−35
Setting the Aspect Ratio
Press the ASPECT button on the remote control to cycle through the options available for the current input signal.
For MP (Media Player), VIDEO
• FULL ➙ ZOOM ➙ NORMAL
For DVI, DisplayPort1, DisplayPort2, VGA (RGB), OPTION*
1
, COMPUTE MODULE*
2
• FULL ➙ 1:1 ➙ ZOOM ➙ NORMAL
*
1
: This function depends on which Option Board is installed in the monitor.
*
2
: This input is available when the optional Raspberry Pi Compute Module Interface Board and Raspberry Pi Compute Module are installed.
For VGA (YPbPr), HDMI1, HDMI2
• FULL ➙ WIDE ➙ DYNAMIC ➙ 1:1 ➙ ZOOM ➙ NORMAL
Aspect ratio of
image
Unchanged view*
2
Recommended selection for picture
aspect*
2
Description
4:3 [NORMAL] Reproduces the aspect ratio that is sent from
the source.
[DYNAMIC] Expands a 4:3 picture to fill the entire screen
with non-linearity. Some of the outside image
area will be cut off due to expansion.
Squeeze [FULL] Fills the entire screen.
Letterbox [WIDE] Expands a 16:9 letter box signal to fill the entire
screen.
*
2
: Gray areas indicate unused portions of the screen.
1:1: Shows the image in a 1 by 1 pixel format.
ZOOM
• The zoom function increases the image size, which expands the image beyond the active screen area. The parts of the
image outside the active screen area are not shown.
ZOOM
ZOOM
To Next Page
Loading...
Need help?
General
