21
OPERATOR MAINTENANCE
1. It is recommended to let forms cool for one-half hour, from the laser printer, before folding. This allows toner to set on
the forms and static electricity to discharge. A paper jogger is recommended for best results. The jogger squares the
forms and dissipates heat and static electricity created by laser printers.
2. Clean in-feed tires and fold rollers with recommended roller cleaner and cotton cloth to remove paper dust and toner.
A damp cloth with water is the best alternative.
CAUTION: Do not use any chemicals other than the recommended roller cleaner or water.
Fig. 18
Fold Rollers
1. Make sure machine is turned off and unplugged. All folders
have four (4) rubber rollers (Fig. 17).
2. Remove the upper and lower fold tables.
3. Using recommended roller cleaner, spray a new cotton
cloth until the cloth is saturated. Wipe the wet cloth in
a back and forth motion making sure to clean the entire
surface of the fold rollers. Next use a dry cloth and wipe off
excess toner. The cloth should be covered with black toner
surplus from cleaning the rollers.
4. Run 10-15 sheets of blank copy paper through the folder to
ensure all cleaner has been removed from the fold rollers.
Running blank sheets will remove any excess residue of
cleaner on the rollers.
CLEANING PROCEDURES:
© 2009 Neopost USA Inc. All rights reserved.
To Next Page
Loading...
Need help?
General
