NetComm N300 User Manual

ADSL2+/3G Wireless N300 4-Port Modem Router YML15WN
40 www.netcomm.com.au
LAN
This screen allows you to congure the Local Area Network (LAN) interface on your Router.
See the eld descriptions below for more details.
Option Description
IP Address Enter the IP address for the LAN interface
Subnet Mask Enter the subnet mask for the LAN interface
Enable IGMP Snooping Enable by ticking the box
Standard Mode: In standard mode, multicast trafc will ood to all bridge ports
when no client subscribes to a multicast group.
Blocking Mode: In blocking mode, the multicast data trafc will be blocked.
When there are no client subscriptions to a multicast group, it will not ood to
the bridge ports.
Enable LAN side Firewall Check box to enable Firewall on LAN
Disable DHCP Server Disables the DHCP server. Only to be done if Static IP address is set up
Enable DHCP Server Select Enable DHCP server and enter your starting and ending IP addresses
and the lease time. This setting congures the router to automatically assign IP,
default gateway and DNS server addresses to every DHCP client on your LAN
Enable DHCP Server Relay To relay DHCP requests from the subnet with no DHCP server on it to a DHCP
server on other subnets. DHCP Server Relay is disabled by default. To access
enable DHCP relay, please un-tick NAT enable rst, that means to disable NAT
rst, and then press save button.
Congure the second IP Address
and Subnet Mask for LAN
Interface
Congure a second IP address by ticking the checkbox shown below and enter
the following information:
Enter the secondary IP address for the LAN interface.
Enter the secondary subnet mask for the LAN interface.

NetComm N300 Specifications

General

Brand	NetComm
Model	N300
Category	Wireless Router
Language	English