Factory default settings
To reset the extender to factory default settings, you can use the Factory Reset button
on the side panel or you can log in and click the onscreen RESET button. For more
information, see Return the extender to its factory default settings on page 50.
The following table shows the factory default settings.
Table 2. Factory default settings
Default SettingsFeature
EnabledSmart Setup
EnabledWiFi communication
NETGEAR_EXTWiFi network name (SSID)
DisabledSecurity
Auto
1
Transmission speed
Varies by regionCountry/region
802.11ac, 802.11n, 802.11g, 802.11b, 802.11aOperating mode
Max 600 MbpsData rate in the 2.4 GHz band
Disabled by default
(When enabled the max data rate is 1733 Mbps)
Data rate in the 5 GHz band
Server and client are enabledDHCP
1
Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and environmental
factors, including volume of network traffic, building materials and construction, and network overhead lower actual
data throughput rate.
User Manual63Supplemental information
AC2200 Nighthawk X4 X4 WiFi Mesh Extender
To Next Page
Loading...
Need help?
General