To enable a LAG on the switch:
1.
Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The HOME page displays.
4.
From the menu at the top of the page, select SWITCHING > QOS .
The Quality of Service (QoS) page displays.
5.
From the menu on the left, select LINK AGGREGATION.
The LINK AGGREGATION page displays.
6. Click the button under the LAG that you want to enable.
The button bar for a LAG that is enabled displays green.
7. Click the APPLY button.
Your settings are saved.
Manage multicast
Multicast IP traffic is traffic that is destined to a host group. Host groups are identified
by Class D IP addresses, which range from 224.0.0.0 to 239.255.255.255.
Internet Group Management Protocol (IGMP) snooping allows the switch to forward
multicast traffic intelligently. Based on the IGMP query and report messages, the switch
forwards traffic only to the ports that request multicast traffic, rather than to all ports,
which could affect network performance.
IGMP snooping helps to optimize multicast performance and is especially useful for
bandwidth-intensive IP multicast applications such as online media streaming
applications.
User Manual61Manage the Switch in Your
Network
Gigabit Ethernet Smart Managed Plus Switches Series 3XXEP and 3XXEPP
To Next Page
Loading...
Need help?
General
