The HOME page displays.
4.
From the menu at the top of the page, select SWITCHING > QOS .
The Quality of Service (QoS) page displays.
5.
From the menu on the left, select MULTICAST.
The MULTICAST page displays.
6.
In the VLAN ID Enabled for IGMP Snooping section, enter a VLAN ID in the field.
If you enabled either a port-based VLAN mode or an 802.1Q VLAN mode, the default
VLAN for IGMP snooping is VLAN 1.
7. Click the APPLY button.
Your settings are saved.
Manage blocking of unknown multicast addresses
As a way to limit unnecessary multicast traffic, you can block multicast traffic from
unknown multicast addresses. If you do this, the switch forwards multicast traffic only
to ports in the multicast group that the switch learned through IGMP snooping. By
default, multicast traffic from unknown addresses is allowed.
To manage blocking of unknown multicast addresses:
1.
Open a web browser from a computer that is connected to the same network as the
switch, or connected directly to the switch through an Ethernet cable.
2. Enter the IP address that is assigned to the switch.
A login window opens.
3. Enter the device management password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The HOME page displays.
4.
From the menu at the top of the page, select SWITCHING.
The Quality of Service (QoS) page displays.
5.
From the menu on the left, select MULTICAST.
The MULTICAST page displays.
6.
Enable or disable the blocking of unknown multicast traffic by clicking the button in
the Block Unknown Multicast Address section.
When the blocking of unknown multicast traffic is enabled, the button bar displays
green.
User Manual63Manage the Switch in Your
Network
Gigabit Ethernet Smart Managed Plus Switches Series 3XXEP and 3XXEPP
To Next Page
Loading...
Need help?
General
