1-1
SECTION 1
GENERAL INFORMATION
DANGER
To prevent injury to bystanders, do not operate
this mower in roadside or municipal mowing.
This mower is intended for agricultural use only.
Failure to comply will result in death or serious
injury.
The left and right are determined by standing behind
the unit, looking in the direction of travel.
The PIN plate, 1, is located on the left side of the main
frame. Record this PIN in the front of this manual.
Give your dealer the model and PIN of your disc
mower when ordering parts. Always order genuine
factory parts from your authorized dealer.
BEFORE USING THE NEW MACHINE
1. Thoroughly read and understand this manual.
Pay particular attention to all safety precautions.
2. Check all grease fittings and the gearbox oil
levels to insure that the machine has been
lubricated as recommended in this manual.
3. Check all adjustments to insure that they have
been made as detailed in the “Maintenance”
section of this manual.
After 8 Hours of Operation
1. Check for loose hardware and tighten any loose
bolts.
2. Visually check the entire cutter bar for leakage
and correct any leakage before operation.
3. Check mower drive belts for correct tension and
readjust as required.
WARNING
Disengage the PTO, turn off the tractor engine
and remove the key. Wait for all movement to
stop before leaving the operator’s position.
Never adjust, lubricate, clean or unplug machine
with the engine running. Failure to comply could
result in death or serious injury.
19986828
1
1
To Next Page
Loading...
Need help?
General
