SECTION 1 - GENERAL INFORMATION
A
SAFETY PRECAUTIONS
UNSAFE OPERATING PRACTICES AND IMPROPER USE OF THE SKID-STEER LOADER
AND
ITS ATTACHMENTS ON THE PART OF THE OPERATOR CAN RESULT IN INJURIES. OBSERVE
THE FOLLOWING SAFETY PRECAUTIONS AT
ALL
TIMES:
1. FOR SERVICING, THE LOADER SHOULD BE ON LEVEL TERRAIN, ENGINE STOPPED WITH
THE WHEELS BLOCKED OR THE ENTIRE LOADER SOLIDLY SUPPORTED WITH THE
WHEELS OFF THE GROUND BEFORE SERVICING
ANY
COMPONENT OF THE DRIVETRAIN.
2. FOR SERVICING UNDER THE OPERATOR'S SEAT, RAISE THE SEAT AND PAN ASSEMBLY
UP TO THE RAISED LATCHED POSITION AND SECURELY LATCH.
3. DO NOT OPERATE THE LOADER UNLESS THE SEAT IS LATCHED IN THE OPERATE
POSITION.
4. DO NOT SERVICE THE LOADER WITH A RAISED BOOM UNLESS THE BOOM IS RESTING
ON THE BOOM
LOCK
PINS.
5. DO NOT SERVICE THE LOADER WITH THE ENGINE RUNNING UNLESS THE LOADER IS
PROPERLY AND SECURELY SUPPORTED WITH
ALL
FOUR WHEELS OFF THE GROUND.
6. USE CAUTION WHEN SERVICING THE UNIT AROUND MOVING PARTS.
7. DO NOT TILT THE BOOM AND
CAB
WITHOUT PROPER INSTRUCTION.
8. DO NOT TILT THE BOOM AND
CAB
WITHOUT USING THE PROPER
CAB
TILTING TOOL.
9. REINSTALL
ALL
SHIELDS REMOVED FOR SERVICE.
10. NEVER LOOSEN
ANY
HYDRAULIC CONNECTIONS BEFORE RELIEVING THE PRESSURE IN
THE HYDRAULIC SYSTEM.
11. WEAR EYE PROTECTION SUCH
AS
GOGGLES, ETC.
12. WEAR EAR PROTECTION SUCH
AS
EAR PLUGS, ETC. WHEN YOU FEEL THE NOISE LEVEL
IS UNCOMFORTABLE.
13. IF
ANY
SERVICING OR ADJUSTMENTS REQUIRE THE BATTERY TO
BE
DISCONNECTED,
DISCONNECT THE (-) NEGATIVE GROUND CABLE.
14. WHEN SERVICING ELECTRICAL COMPONENTS, DISCONNECT THE (-) NEGATIVE
GROUND CABLE.
15. IF THE ELECTRONIC INSTRUMENT CLUSTER (EiC) REQUIRES REMOVAL FROM THE DASH
AREA
OR THE SKID-STEER LOADER DISCONNECT
THE(-)
NEGATIVE GROUND BATTERY
CABLE. THIS
WILL
SHUT OFF POWER TO THE EiC
AND
PREVENT DAMAGE TO THE EiC
BOARD OR BLOWING THE 5-AMP FUSES IF THE BOARD IS ACCIDENTALLY GROUNDED.
16. IF WELDING IS REQUIRED ON THE SKID-STEER LOADER, DISCONNECT THE (-) NEGATIVE
GROUND CABLE. FAILURE TO DISCONNECT THE BATTERY MAY RESULT IN DAMAGE TO
THE EiC (ELECTRONIC INSTRUMENT CLUSTER) MONITORING SYSTEM AND OTHER
ELECTRICAL COMPONENTS.
17. IF WELDING IS REQUIRED ON
AN
ATTACHMENT, REMOVE THE ATTACHMENT FROM THE
SKID-STEER LOADER.
1-4
Find manuals at https://best-manuals.com
To Next Page
Loading...
Need help?
General
