18
TROUBLE SHOOTING
TROUBLE SHOOTING
Problem Possible causes What to do
The display on the front
panel does not light up.
No sound or picture, but the
front panel shows red light.
Main cable is not connected.
The is in standby mode.receiver
Check that the main cable is plugged into
the power socket.
Press the standby button.
No sound or picture.
No signal or weak signal.
Check the cable connections, antenna
and other equipment connected between
the antenna and the receiver.
Bad picture / blocking
error.
Signal is too strong.
Connect a signal attenuator to the
antenna input.
Antenna noise factor too high.
Change to an antenna with lower noise
factor.
The antenna is faulty. Change the antenna.
The RCU is not working.
Battery exhausted.
Change the batteries.
RCU is incorrectly aimed.
Aim RCU at the , or check that
nothing blocks the front panel.
receiver
Note : If you failed to solve problems by all the recommended actions above, please contact
your dealer or a customer service adviser.
To Next Page
Loading...
General