When connection to NIBE indoor module / control module
(VVM / SMO) is ready, you can control your unit via the indoor
module / control module.
Control, general
The indoor temperature depends on several different factors.
Sunlight and heat emissions from people and household
machines are normally sufficient to keep the house warm
during the warm seasons. When it gets colder outside, the
climate system needs to help heat the house. The colder it
is outside, the warmer radiators and underfloor heating
systems have to be.
Control of the heat production is performed based on the
"floating condensing" principle, which means that the tem-
perature level needed for heating at a specific outdoor
temperature is produced based on collected values from
the outdoor and supply temperature sensors. The room
sensor can also be used to compensate the deviation in
room temperature.
Heat production
The supply of heat to the house is regulated in ac-
cordance with the selected heating curve setting.
After adjustment, the correct amount of heat for
the current outdoor temperature is supplied. The
supply temperature of the heat pump will oscillate around
the theoretically required value.
OWN CURVE
The indoor module/control module have pre-programmed,
non-linear heating curves. It is also possible to create your
own defined curve. This is a partially linear curve with a
number of break points. You select break points and the
associated temperatures.
Hot water production
Hot water charging starts when the temperature
has fallen to the set start temperature. Hot water
charging stops when the hot water temperature at
the hot water sensor has been reached.
For temporary higher hot water demand, there is a function
called “More hot water”.
For temporary higher hot water demand, there is a function
that allows the temperature to be raised temporarily for up
to 12 hours or by a one time increase (can be selected in
the menu system).
It is also possible to put the installation in holiday mode,
which means that the lowest possible temperature is main-
tained without the risk of freezing.
Additional heat only
The indoor module (VVM), which is connected to
F2120, can be used with the additional heat alone
(electric boiler) to produce heating and hot water,
for example before the outdoor module is installed.
Alarm indications
If there is an alarm, the status lamp lights red on
the indoor module’s / control module’s (HWM / SMO)
display. Detailed information, depending on the
fault, is shown in the display. An alarm log is created
with each alarm, containing a number of temperatures, times
and operating status.
The display
The indoor module / control module (HWM / SMO)
is controlled using a clear and easy-to-use display.
Instructions, settings and operational information
are shown on the display. You can easily navigate between
the different menus and options to set the comfort or obtain
the information you require.
Visit myuplink.com and click the "Software" tab to download
the latest software for your installation.
myUplink
With myUplink you can control the installation –
where and when you want. In the event of any
malfunction, you receive an alarm directly to your
e-mail or a push notification to the myUplink app,
which allows you to take prompt action.
Visit myuplink.com for more information.
SPECIFICATION
You need the following in order for myUplink to be able to
communicate with your system:
• wireless network or network cable
• Internet connection
• account on myuplink.com
We recommend our mobile apps for myUplink.
NIBE F2120 13
Functions
To Next Page
Loading...
Need help?
General
