Nice MORX User Manual

14
1234
 or 
5.2) KEYPAD programming
This part analyses the access control system programming
procedures when KEYPADS are used.
In the KEYPAD mode, the two output relays are associated with the
confirmation keys  and .
Key  is confirmation for the relay 1 output
Key  is confirmation for the relay 2 output
In the PROFESSIONAL mode, key  is also used for “confirmation”
during programming phases.
In the PROFESSIONAL mode, key  is also used for “cancelling” the
programming phase.
While entering the combination, no more than 10 seconds must
elapse between pressing one key and pressing the next; after this
delay the combination must be entered again from the start.
Each combination may activate just one or both outputs.
in the first case, enter it and press the corresponding confirmation key only
(e.g.:  is only valid for output  and not for output ). in the second
case, press either of the two confirmation keys (e.g.:  is valid both for
output  and output ).
In the EASY mode, a single combination can be given to all
users, or one for just output  and another for just output .
In the PROFESSIONAL mode, each user or group of users
can be given their own combination in order to make it easy to
add or remove users.
1. Enter the combination
2. Press the key to activate the output
Table “A1” Using the Keypad (users) Example

Nice MORX Specifications

General

Brand	Nice
Model	MORX
Category	Control Systems
Language	English