Nice MORX User Manual


29
GB
C
A
R
D
C
A
R
D
C
A
R
D
1. Hold the CARD up to the reader and wait 1 second
Output N° 1 will activate after a second
Table “D2” Using the CARD to activate output N°1 with the DYNAMIC option Example
Table “D3” Using the CARD to activate output N°2 with the DYNAMIC option Example
5.6) Transponder CARD programming
This part analyses the access control system programming
procedures when CARDS and the relative READER are used.
There are two different programming modes:
EASY, with just the basic functions.
PROFESSIONAL, with more specific functions.
In the PROFESSIONAL mode, one or two CARDS, called
MASTERS (see table F1 and F2) must be used for all
programming operations.
The choice between one mode and the other must be made while the
memory is empty and depends on the programming mode used to enter the
first CARD. After choosing between the EASY or PROFESSIONAL
programming mode, this cannot be modified unless the memory is completely
deleted.
1. Hold the CARD up to the reader
Output N°1 or N° 2 will activate depending on whether the CARD has been programmed with the STATIC 1 or STATIC 2 option
Table “D1” Using the CARD with the STATIC 1 or 2 option Example
1. Hold the CARD up to the READER
2. the CARD immediately after the recognition tone
3. Then hold the CARD up to the READER again
Output N° 2 will activate
C
A
R
D
C
A
R
D
C
A
R
D

Nice MORX Specifications

General

Brand	Nice
Model	MORX
Category	Control Systems
Language	English