11
Part Names
1
This chapter describes the name of each part of the product.
When using the product for the first time, refer to this chapter and check the name and the position of each
part. Also refer to this chapter for names and positions of the controls whenever necessary.
• The components of the microscope can be selected to suit the application. However, the lamp, the dia
pillar illuminator, and the power supply device must be used in specific combinations. Do not use these
devices in an inappropriate combination. For combinations of the lamp, the dia pillar illuminator, and the
power supply device, refer to page 55.
• For details on microscopy procedures, see Chapter 2, “Microscopy”. For details on the operation of each
part, see Chapter 3, “Operation”.
• If the microscope has not been assembled yet, first refer to Chapter 4, “Assembly”.
To Next Page
Loading...
Need help?
General
