7978
1
Hold FUNCTION button and rotate command dial until the
Function Area indicator indicates blinking h in the
Exposure Compensation Area. Then hold SET/! button and
rotate command dial until desired compensation value appears
in place of frame counter on LCD panel. h also appears inside
viewfinder.
(In the example above, +1
2
/3 compensation is set.)
To modify exposure control (i.e., from the ISO standard) use the
exposure compensation function. You can modify exposure
control from -5EV to +5EV in
1
/3 steps is possible. In flash
photography, flash output level is also compensated. After
taking your photographs, be sure to reset the control to "0" to
resume normal operation.
EXPOSURE COMPENSATION FUNCTION
Without compensation
With compensation
(Centre-Weighted Metering)
2
To complete setting, remove your finger from SET/!
button. Once set, exposure compensation remains fixed
until reset. Although h stays on to indicate that exposure
compensation is on, the compensation value disappears from
the readout when you remove your finger from SET/! button.
Inside the viewfinder, h appears.
To confirm compensation value on the LCD panel, Hold
FUNCTION button and rotate command dial so that the Function
Area indicator indicates blinking h, then press SET/! button.
3
After shooting, be sure to reset amount of compensation
to “0” to resume normal operation.
• You can cancel exposure compensation function by setting
QR number to "0". In this case camera resets to the factory-
set initial settings ( page 70).
F70D I/MêÊçsâ¸í˘ 03.1.16 5:33 PM Page 78
To Next Page
Loading...
Need help?
General
