To Next Page

To Previous Page

WET VACUUMING

Steps to follow in ﬁ tting the machine with optional attachments for wet vacuuming.

1 Disconnect the recovery hose (33) from the squeegee mount. Connect the coupler and hose from the wand kit to the recovery hose.

2 Attach suitable wet pick-up tools to the hose. (An optional Vac Wand Kit PN56116355 is available from Nilﬁ sk).

3 Place the magnetic key onto the Smart Key Reader (A) and press the Power Switch (B). While standing alongside the machine (not on the seat) press the

Vacuum/Wand Switch (L). The vacuum motor and the pump will run continuously until the switch is pressed again to turn it OFF. The Wand Indicator (C17)

is displayed. NOTE: Pressing the Vacuum/Wand Switch (L) while seated on the machine will cause the squeegee to lower and the vacuum motor(s) to run

while machine is moving forward. The Vacuum Indicator (C16) will be displayed.

SERVICE NOTE: Refer to the service manual for detailed functional descriptions of all controls and optional programmability.

FIGURE 8