6
3.1. Transportation
1. When storing or moving the heat pump, the heat pump should be in an upright position. Never
Tilt the unit more than 30 degrees
2.When moving the heat pump, do not lift it by the water unions as this may damage the titanium
heat exchanger inside the heat pump.
3.2. Notice Before Installation
1.The water unions are not designed to support the weight of unsupported flexible tubing. The
heat pump must be connected with properly supported tubing that does not pull or strain on the
heat pump unions!
2. To ensure heating efficiency, the length of the piping between the pool and the heat pump
should be less than 30ft.
3.3. Installation Instructions
WARNING: The heat pump must be installed by a qualified technician. Improper
installation, adjustment, service, maintenance or use can cause fire, electrical shock
or other conditions which may cause injury or property damage.
This section is provided for information purposes only and must be adapted according
to the actual site conditions.
To Next Page
Loading...
Need help?
General
