Fixing module to the bracket
Fixing module to the bracket
1. Connect the module with bracket. Align1. Connect the module with bracket. Align
the holes on module's back to the fixingthe holes on module's back to the fixing
studs on mounting bracket.studs on mounting bracket.
2. Push the module down until it stops2. Push the module down until it stops
3. Fix the four M8x12 screws.3. Fix the four M8x12 screws.
. . ConConnecnect t the the wriwrist st raprap..
..
4. Fix the two M5 (T25) screws by the front panel.4. Fix the two M5 (T25) screws by the front panel.
5 5 stst
11
22
11
Placing module on a wallPlacing module on a wall
1. 1. ..
22. . L L aannd d ppoossiittiioon n iit t aaggaaiinnsstt
ththe e wawallll, , titing ng onon
3.3.
4.4.
Fix the upper mounting screwsFix the upper mounting screws
ift the moduleift the module
ffiit t iit t tthhe e ssccrreewwss..
Tighten the upper screws.Tighten the upper screws.
Insert the lower screws andInsert the lower screws and
tighten them.tighten them.
-5--5-
22
33
44
Wall installation (continued)Wall installation (continued)
Check listCheck list
Module is firmly and Module is firmly and propeproperly fixed to rly fixed to the surface.the surface.
33
Wrist strapWrist strap
to ESD studto ESD stud
5544
To Next Page
Loading...
Need help?
General
