Installation, Configuration, and Programming
PN 15842:K 7/23/2002 25
Section 4 Installation, Configuration, and
Programming
This section provides an overview of installation procedures for ACS
annunciators.
For wiring & programming details that are unique to a specific fire alarm
control panel, refer to that panel's appendix in this manual, and to that panel's
programming guide (see Section 1.2 “Related Documentation” for part
numbers). Refer to the appendix section if, for example, you need to locate the
terminal block on the control panel to which you would connect a particular
ACS circuit.
For operating information, see Section 5 “LED and Keypad-Switch Functions”
which provides details on LED and switch functions.
4.1 Installation Checklist
1. Mount and ground the cabinet or backbox (Section 4.3).
2. Pull wiring into backbox and connect removable terminal blocks to wires
(Section 4.3, Section 4.5, Section 4.9).
3. Connect shield for EIA-485 circuit (Section 4.6).
4. Connect Earth Ground to a mounting screw on the backbox or cabinet
(Section 4.8).
5. Place slide-in labels in annunciators and expanders; attach adhesive labels
to trim plates (Section 4.10).
6. Mount key switch and/or phone jack onto annunciators (Section 4.11).
7. Mount and connect annunciators and expanders (Section 4.4).
8. Configure annunciators for the number of installed expanders (Section
4.12.3).
9. Set DIP switches & module addresses (Section 4.12).
10. Make all electrical connections:
• EIA-485 circuit & End-of-line resistor (Section 4.5 and Section 4.7).
• Power circuit (Section 4.9)
• ACM-16AT, ACM-32A and expanders only: Supervising devices
(Section 4.14)
11. Attach doors to semi-flush-mount backboxes (Section 4.4).
12. Power up system according to instructions in the control panel manual.
13. Program the control panel (Section 4.15).
14. ACM-24AT, ACM-48A and expanders only: Set LED colors to correspond
with panel-programming selections (Section 5.1).
15. Test annunciators (Section 4.15).
To Next Page
Loading...
Need help?
General
