Installation, Configuration, and Programming
34 PN 15842:K 7/23/2002
4.10 Labeling Annunciators & Expanders
Insert custom display labels (slide-in labels)
Remove the center pages of this manual. If using the
custom user display labels, type the appropriate
information on the labels. Carefully cut out the labels;
to ensure the best fit, cut directly along the dotted line
surrounding each label. Insert them into the
annunciator by slipping them into the label slots on the
back side of the annunciator face plate (see Figure 4-
15).
Note: ACM-24AT, ACM-48A, and expanders provide
a plastic protector sheet to insert with the slide-in
labels. Labels should be slightly narrower than the
protector sheet to allow easier insertion.
Notifier’s Magni•Fire CD contains LabelEase—a
program for customizing professional slide-in labels.
Apply adhesive label onto flush-mount dress plate
If mounting the annunciator onto a
flush-mount dress plate, remove
backing from the adhesive-backed
Annunciator Label and stick the
label to the bottom of the dress plate
as shown in Figure 4-16.
Note: A special-purpose label ships
with the optional Annunciator Key
Switch and with Annunciator Phone
Jack. This label replaces the one
shipped with the annunciator. It has
holes that align with the holes on the
dress plate, providing a location to
mount the devices.
Figure 4-15
Slide-in Labels
ACM24-labels.cdr
Figure 4-16 Applying the
Adhesive Annunciator Label
abf1plate.cdr, lbl15824.tif
To Next Page
Loading...
Need help?
General
