22
G
B
4. Unpacking and setting up
1. Take the individual parts out of the
packaging.
2. Check that the individual parts are complete
(see “1.3Components“ on page19) and
undamaged.
3. Clean the device thoroughly before using it
for the first time (see “6.Cleaning and
storing“ on page25).
4. Set up device on a firm, level, non-slip, heat-
resistant surface so that it cannot tip over.
5. Operating the device
5.1 Select the operating mode,
switching on and off
You must specify whether the device should be
connected to the mains 220-240 V (domestic) or
to the 12 V vehicle electrical system:
1. To use the device on the mains
place the switch 3 on the symbol
shown next to this paragraph.
2. To use the device in the car's electrical
system place the switch
3
on the
symbol shown next to this paragraph.
Note:
– New vehicles, in particular, have low-
voltage protection as standard to protect
the electronic components fitted in the
vehicle. This can lead to short battery
running times and premature interruption
of the heating-up process. If necessary,
the device will then have to be operated
with the engine running.
– Never let the engine of the vehicle run in
enclosed areas (e.g. in garages,
underground car park, etc.).
– Use the device only with the vehicle at a
standstill.
3. To turn the device off, push
the button 3 in the "OFF"
position.
To Next Page
Loading...
Need help?
General
