The Status Monitor> 45
S
YSTEM
CONFIGURATION
MENU
This menu adjusts general printer settings to suit the way you
prefer to work.
SYSTEM CONFIGURATION MENU
ITEMS SETTINGS EXPLANATION
POW SAVE TIME 5 MIN
15 MIN
30 MIN
60 MIN
240 MIN
Adjusts the idling time before the
printer automatically switches into
power saving mode. In this mode
power consumption is reduced to a
low level required to just keep the
printer operating and ready to
receive data. When a job is sent the
printer will require a warm-up time
of up to 1 minute before printing can
begin.
CLEARABLE
WARNING
ON
JOB
When ON, non-critical warnings,
such as requests for a different
paper size, can be cleared by
pressing the ON LINE button. When
set to JOB, they are cleared when
the print job resumes.
MANUAL
TIMEOUT
OFF
30 SEC
60 SEC
Specifies how many seconds the
printer will wait for paper to be fed
in manual feed mode before
cancelling the job.
WAIT TIMEOUT OFF
5~90~300
Specifies how many seconds the
printer will wait when received data
pauses before forcing a page eject.
In PostScript Emulation mode the
job will be cancelled if timeout
occurs.
LOW TONER CONTINUE
STOP
Specifies whether the printer should
continue printing even after a low
toner condition is detected.
JAM RECOVERY ON
OFF
Specifies whether the printer should
perform jam recovery after a paper
jam has occurred. If ON, the printer
will attempt to print again any pages
lost due to a paper jam once the jam
has been cleared.
ERROR REPORT ON
OFF
Specifies whether to print an error
report when an internal error occurs.
To Next Page
Loading...
Need help?
General
