Installing additional memory> 69
I
NSTALLING
ADDITIONAL
MEMORY
This section explains how to install additional RAM memory into
your printer as a memory upgrade.
O
RDER
CODES
Use the following order codes for additional memory:
> 64MB RAM – 01110301
> 256MB RAM – 01110302
M
EMORY
UPGRADE
The basic printer model comes equipped with 32MB of main
memory. This can be upgraded with an additional memory board
containing 64MB or 256MB, giving a maximum total memory
capacity of 288MB.
Installation takes a few minutes, and requires a medium size
cross-head (Philips type) screwdriver.
1. Switch the printer off and disconnect the AC power cable.
2. Press the cover release and open the printer’s top cover
fully.
WARNING!
If the printer has been powered on recently, the fuser
will be hot. This area is clearly labelled. Do not touch.
To Next Page
Loading...
Need help?
General
