Replacing consumable items> 65
F
USER
REPLACEMENT
The fuser is located inside the printer just behind the four image
drum units.
Switch off the printer and allow the fuser to cool for about
10 minutes before opening the cover.
1. Press the cover release and open the printer’s top cover
fully.
WARNING!
If the printer has recently been powered on, some fuser
components will be very hot. Handle the fuser with extreme
care, holding it only by its handle, which will only be mildly
warm to the touch. A warning label clearly indicates the
area. If in doubt, switch the printer off and wait at least
10 minutes for the fuser to cool before opening the printer
cover.
To Next Page
Loading...
Need help?
General
