Menu functions > 51
USB
MENU
This menu controls the operation of the printer’s USB data interface.
N
ETWORK
MENU
This menu controls the operation of the printer’s 10Base-T/100Base-TX network interface.
ITEM SETTINGS EXPLANATION
SOFT RESET ENABLE / DISABLE Enables or disables the SOFT RESET command.
SPEED 12Mbps / 480Mbps Selects the interface speed.
OFFLINE RECEIVE ENABLE / DISABLE Enables or disables this function. When set to Enable,
the interface retains a receive possible state even when
switching to Offline. Interface sends the BUSY signal
only when the receive buffer is full or a service call
occurs.
SERIAL NUMBER ENABLE / DISABLE Specifies whether to ENABLE or DISABLE a USB serial
number.
The USB serial number is used to identify the USB
device connected to your PC.
NOTE
When you have changed any settings in the USB MENU, turn the printer OFF,
then ON again.
ITEM SETTINGS EXPLANATION
TCP/IP ENABLE / DISABLE Enables or disables this network protocol.
IP VERSION IP v4
IP v4+v6
IP v6
Applies to C331 and C531/ES5431 only.
Sets up the IP version.
Operates with IPv4 only (not valid with IPv6).
Operates with both IPv4 and IPv6.
Operates with IPv6 only (not valid with IPv4).
From this stage, if IPv6 only is set from UI, for example
Telnet, “IP v6” appears as the value of IP Version on the
operation panel. “IP v6” will disappear from the value if
“IP v4” or “IP v4+v6” is selected.
Display Condition: TCP/IP should be enabled.
NETBEUI ENABLE / DISABLE Applies to C331 and C531/ES5431 only.
Enables or disables this network protocol.
NETBIOS OVER TCP C331: ENABLE /
DISABLE
C531/ES5431: ENABLE
/ DISABLE
Applies to C331 and C531/ES5431 only.
Sets Enable/Disable of NetBIOS over TCP protocol.
Display Conditions:
> > TCP/IP should be enabled.
> > IP Version is not IPv6.
NETWARE C331: ENABLE /
DISABLE
C531/ES5431: ENABLE
/ DISABLE
Applies to C331 and C531/ES5431 only.
Enables or disables this network protocol.
ETHERTALK ENABLE / DISABLE Applies to C331 and C531/ES5431 only.
Enables or disables this network protocol.