- 28 -
Parts Nomenclature and Functions
AppendixBefore use
1
Setting Up
2
Printing
3
Basic Device Operations
4
Index
Adjusting the Control Panel
Brightness
Use the following procedure to adjust the
brightness of the liquid crystal panel.
Memo
The brightness (backlight) of the liquid crystal panel can
be set individually for during control panel operations and
when in power save mode.
1
Press either the scroll button or
on the control panel to display the
"Functions" screen.
2
Press the scroll button several times
to select the [Admin Setup], and then
press the [OK] button.
3
Use the 10-key pad to enter the administrator
password. The default factory-set password is
"aaaaaa". Press the [OK] button after entering
each individual character.
4
Select [Panel Setup], and press the [OK]
button.
5
When adjusting the brightness for
during control panel operations, select
[Panel Brightness During Operating],
and press the [OK] button.
When adjusting the brightness for when in
power save, select [Panel Brightness While
Power Save], and press the [OK] button.
6
Press the [ON LINE] button to return to
the standby screen.
To Next Page
Loading...
Need help?
General
