Oki C9650dn Network And Configuration Guide

TCP/IP > 85
TCP/IP
P RINTER CANNOT FIND THE NETWORK INTERFACE CARD
> Turn the printer off for 15 seconds and then on again.
> Confirm that the network interface is enabled on the
printer.
> Make sure there is a response to the ping command.
> Make sure the network cable is correctly connected and
that the green LED close to the printer’s network interface
is lit. If not, change the cable and try again.
> Run the Self-diagnostic test (with printer on, press and
hold the Test button on the print server for 3 seconds,
then release it).
> Make sure that the IP Address, Subnet Mask and Gateway
are correct.
> Make sure that the TCP/IP protocol is set to Enable.
> Reset the network interface card to the factory default
settings.
> If DHCP, BOOTP and RARP are not used, ensure they have
been set to Disable.
C ANNOT PRINT WITH LPR AND FTP
> Turn the printer off for 15 seconds and then on again.
> Make sure there is a response to the ping command.
> Make sure the network cable is correctly connected.
> Change the cable and try again.
> Make sure the host name and IP address are configured in
the workstation.
> Make sure the printer port name is configured in the
workstation.
> There are three port names: lp, euc and sjis. Use lp by
default as euc and sjis are specific to printers with
PostScript available.

Oki C9650dn Specifications

Performance

print speed color	36 ppm
print speed mono	40 ppm
time to first page color	10.5 sec
time to first page mono	9 sec
warm-up time	85 sec
resolution	1200 x 600 dpi

Memory

standard RAM	512 MB
maximum RAM	1, 024 MB
flash memory	4 MB
hard disk drive	40 GB

Power

power consumption operating typical	780W
power consumption peak	<1500W
power consumption standby	200W
power consumption power save	33W

Weight and Dimensions

size	23.6" x 24.6" x 18.5"
weight	167.5 lb
weight with consumables	76.0 kg