Loading paper > 37
R
EGISTERING
CUSTOM
SIZES
To load custom size paper, you need to register the width and length of the paper before
printing.
The range of the sizes you can set differs according to the paper tray.
1. Press the SETTING button on the control panel.
2. Using the Down arrow key, scroll to Paper Setup and press OK.
3. Using the arrow keys, scroll to the required paper tray and press OK.
4. Using the Down arrow key, scroll to Custom and press OK.
5. Using the keypad, enter the Width and Length of the loaded paper.
Press the Right arrow key to move between digits.
6. Press OK.
7. Press the Left arrow key to exit the menu.
TRAY AVAILABLE SIZE RANGE
Tray 1 Width: 105 to 216 mm (4.1 to 8.5 inches)
Length: 148 to 356 mm (5.8 to 14.0 inches)
Tray 2 (optional ) Width: 148 to 216 mm (5.8 to 8.5 inches)
Length: 210 to 356 mm (8.3 to 14.0 inches)
MP tray Width: 64 to 216 mm (2.5 to 8.5 inches)
Length: 127 to 1321 mm (5.0 to 52.0 inches)
NOTE
For tray 1 and tray 2, you can configure the
Custom setting only when Paper
Size
is set to Custom.
The available size range for duplex printing is the same as that for tray 2.
To Next Page
Loading...
Need help?
General
